Recent content by On-Wheel

  1. O

    Comfortable shop shoes?

    Tried murells for a bit and been doing Keen a few years. I heard of those brands from hikers.I don’t remember the other brands to try after Keen. For me the Keen was a step up but been thinking of finding better. They quit making my go to Rocky years ago.The search is real.lol
  2. O

    Gearwrench Quality

    I was looking at GW 28 pic comb 6 point wrench set for $98 The reviews on Amazon were bad. A 1” SO wrench is 55 bucks.geez
  3. O

    Question for the detailers

    The old $50 HF 8mm kicks ****. I’d buy another one if they still had them.
  4. O

    Milwaukee M12 tools that are worth it?

    Same as all the rest. YouTube has a comparison video using noise db. M12 hack saw is great.I think I have the bigger one.
  5. O

    Milwaukee M12 tools that are worth it?

    M12 grease gun is great.
  6. O

    Change from electric 5k watt 240v heater to hydronic unit heater?

    That electric 5k probably cost a buck an hour to run.
  7. O

    Push Pull Mig for AL. Better choice than tig for me?

    Nice write up @dr_clyde !
  8. O

    The DeWalt Addiction Thread

    8ah batteries are the bomb 5’s not as good by a long shot Very noticeable run time in a grinder and small blower. No idea what the flex volts are like.
  9. O

    Milwaukee Power Tools Deal Permathread

    He just had a vid of some drug dealer that had a million dollars of stolen Milwaukee tools from HD.His house was stacked to the ceiling with new tools.Not a fan but was wild to see. Starting to think hot deals means new tools on the way? Like somebody else mentioned not necessarily a bad deal.
  10. O

    Liftmaster Belt Drive - how to remove / replace the pulley on the motor?

    See the big disk below sprocket? That’s where there screwed to the motor housing. Pulley https://www.amazon.com/dp/B0722NPX9X/?tag=atomicindus08-20
  11. O

    Liftmaster Belt Drive - how to remove / replace the pulley on the motor?

    You’ll probably need a new shaft belt pulley combo.Look on eBay.And or call customer service. The chain sprocket is probably red lock tighted in.Or pressed in ? Chances are it’ll break off trying to remove it. It’s half the OD size of the shaft.Made to break. There’s a good chance it is an...
  12. O

    Saylor Beall 705-5 Pump RPMs

    I need to switch out my mag start to a soft start.The motor now takes off like on a drag strip.Burning rubber I tell yah!
  13. O

    Saylor Beall 705-5 Pump RPMs

    You guys motivated me.Swaped 6.75 to 7.75 ! 1740 should be close to 800 now. The pulley was torched off its motor so I used my shop press to disassemble . Was an outside unit so it was on there.Made my hydraulic press bleed.lol The smaller one came off easy.
  14. O

    Removing Georgia red clay stains from 1 month old concrete

  15. O

    Removing Georgia red clay stains from 1 month old concrete

    Look for a local commercial power washing supply house.They will have what you need. Take a picture for them to see your floor. YouTube will tell you.All in house products are called something different.That’s why I say get it local. Or just use Muriatic acid.One gallon of water to 12 oz in a...
See more
Top Bottom