Recent content by oNioN
-
O
Piping Size for 45K Mr Heater
I just had a nat gas 60K Reznor installed in my garage. The installer teed off the high pressure side of the manifold at the furnace and put a regulator out by the heater. All of my gas lines are 1/2" OD copper and some black pipe here and there (house built 1994). The run out to the heater...- oNioN
- Post #4
- Forum: Heating and A/C
-
O
Mr Heater 75,000 proper wire size 12-2 or 14-2
According to the Mr Heater website, total unit amps for the 75K is 6.0. Here's the link: http://www.mrheater.com/upload/newsletter/MHUSpecSheetLR.pdf I'm no electrician, but don't you use 14-2 for 15A circuits and 12-2 for 20A circuits? If so, either size wire should work for you. Good...- oNioN
- Post #4
- Forum: Heating and A/C
-
O
Wife says put a heater in the garage!!
Thanks all for the input. I ended up hiring a local HVAC company to come and install a 60K Reznor UDAP. They are charging me $1500 for everything and should be here tomorrow. Everything in my house is nat gas, but he thought they could still go off the low press side of the regulator. I can...- oNioN
- Post #11
- Forum: Heating and A/C
-
O
Wife says put a heater in the garage!!
I have been entertaining bids for the last 2 weeks now. I have pricing from $1500 to $2750. Ouch! Most everyone wants to install the Reznor units in either a 45K btu or 60K btu. My garage is 3 car, 750 - 800 SF, fully insulated walls and ceiling, insulated doors, and 2 ceiling fans. With...- oNioN
- Thread
- Replies: 10
- Forum: Heating and A/C