Orangina's latest activity

errrr... I bought most of my "use every day" tools in the early 70s... so... are they vintage yet? :unsure:

I am a woodworker, and probably 80% of my tools are older than 1950. Plan is to use most of them. I have some of Grampa's tools here...

50's and 60's era made in USA should be plenty good enough to use. I have my "collectable" tools in an old toolbox and sometimes use...

I would say that half of my tools were manufactured during the 60s to 80s era— and bought new. I own WW2 era and “pre-war” tools, but...

Hello from Germany 🇩🇪, here, anything older than 100 years is considered "antique" – whereas the imprecise term "vintage" is applied to...

A couple from my collection…😉 Steve

Thought I would throw another “Duluth Steel” in the mix. Three square sockets and five hex. 5/8” twice.

Hello everyone, as a collector, I am specifically looking for this particular vintage compact 1/4" socket - a...

Hello everyone, HAZET 863 B (1970-1972) This very small ratchet with a 1/4" drive and bendet handle was used on classic VW type 4...

Hello, the next classic find: HAZET 916 (from 1979) ratchet The sliding button (round step pyramid) used to change direction with...

according to standards as ISO 3315 or DIN 3122 the torque is limited by a ratchet or socket with a drive size Nm torque 1/4" 62...

Hazet 916HPLG

Battery powered tools. The batteries are always dead and they don’t fit across brands. Dragging cords and hoses is so much better...

Hello again, another rare old item: Hazet 2562 with its pin 2562 D (1950-1970) double socket wrench with 27x30 mm and matching 12 mm...

Nice find anyway. But this 166N Assistent with black top is from 1982 and later till today - another era than this beetle ;) (Yes, the...