Recent content by Overboost44

Those are very cool. I need some. Currently have a Ferrari F1 car and a Ford GT and that looks like what I will do in my garage.

Thanks for this. I am getting to that point where I will need to start checking prices on all of this. Was set on getting rockwool but it was expensive enough without a price increase. Will look into the varismart but don't think I will need a vapor barrier with radiant and mini-splits on the...

Maybe one on the East and one on the West side to catch the sun? Depends on how important your wall space is to you.

Mine seems to always be about at ground temp with the current setup. I know my neighbor had all of the floor insulation removed but I don't know if they put anything on the walls. It would certainly make sense to do that. OP, I realize the above is OT but maybe it helps you. That said, I am...

That's nice. Do you mean wall insulation or floor joist insulation? I have a good dehumidifier that is brand new. I just want that nice white poly under there. Then I have to seal off the air vents from the inside.

It would be full encapsulation and plenty of lighting. I could get a beach chair and watch TV in my neighbors crawl but his is a good 3'

The reason we don't have basements is because we are on an island. Water table is too high. My problem is that my crawlspace is literally just that. It is about 2.5' deep. Terrible for getting under the house, but I can't imagine what someone would charge to make it deeper. Some people have...

I hate to cut the grass when wet too. When I last cleaned my deck, I sprayed the whole underside with fluid film. Tough to say how long but I bet it improved the cleaning for an entire season. Would recommend to do it each year.

Check out this idea. It would be difficult if the deck is finished. I like the corrugated metal idea but rubber membrane like this could be an option.

I like it. Never would have thought of that. If I did, my garage could be much bigger and have more toys in it.

You are correct. I should have at least divided by 2 and it would have been closer. My apologies.

Just to put it all in one place. The green pipe is significantly thicker than the regular thin wall white PVC and both have belled ends. The white is .59 thickness and $1.80/ft https://www.homedepot.com/p/JM-EAGLE-4-in-x-10-ft-PVC-D2729-Sewer-and-Drain-Pipe-1610/202280933 The green is .127...

You are correct. I didn't search for the thread that this is based off of. You brought up paying for water to mix coolant.

I buy water for my radiator, use it in my batteries and I even buy regular water to drink. Yes, I am on a well but I am not afraid to drink it.

Don't know where you are located but that dumpster cost is high. concrete can be recycled, so if there is C&D or rubble landfill nearby, cost should be minimal. Stego 10 mil is $360 for 14' x 105' but then you also need tape. Not sure what the 15mil costs. Guessing that a large part of that...