Recent content by Oxidd1979

Hmm weird. I'm logged in from tapatalk and I don't see it. It's fine in Chrome when I'm loggued. Sent from my iPhone using Tapatalk

Hi everyone, I have a heater on the ceiling of my garage, 5000 watts, it,s perfect for a -30 or -40 winter. The only problem is that the fan is loud, and my bedroom is right above said heater. Any ways to isolate the vibration of this heater?

Hi The small-coin looks very interesting. Do you ship to Canada? Also, quick questions. 1. How to you finish the edge that is parallel to the garage doors? I dont want snow/water to get under it. 2. Any pictures of how to finish it around a drain in the middle of the garage? Theres a blog...

Bienvenue! Un autre francophone ici, de Montréal.

Did you check out something like this for the heating? http://www.renodepot.com/en/garage-convection-heater-03915163 looks good, and I find that those kind of heaters work better than the construction heater. I'm not sure but I think I read somewhere that those construction heater (red or...

Ah oui, pour l'isolation, je te conseille le sprayfoam. Regarde avec Airmetic Soya.

Hi Jo! Go in the flooring section of the forums, plenty of info there. some guys, like JVB have VCT tiles, thats what I'm planning to do soon. They are not that expensive at HomeDepot. epoxy, racedeck, ceramic/porcelain tiles. All kind of options!

For your insulation question. Yes, sprayfoam may be more expensive, but it's worth it. I was reading somewhere, (dont remember where exactly), that 1.5 inch of closed cell sprayfoam has better insulation than a wall cavity filled with fiberglass or other type of insulation, since the foam will...

Thanks for the tip, but that wont work for me. I dont and an edge like this. basically, my only 'edge' will be the 1/8 of the tile.

Hi guys, I'm planning to install VCT tiles on my garage floor by the end of the summer. I want to go VCT for different reasons, like cost, look, etc etc etc. I dont mind the annual maintenance (wax/buffing). I was just wondering, how to do 'seal' the edge when the VCT ends near the...

Sears is going to be dead in just a few years. Sears Canada just announced this wednesday that they are cutting 1600 jobs in the country. The catalog service is going to be in the Philipines and Bulgaria with IBM.

I would just redo those ramp in pressure treated wood so they can last for a bit until I find the best solution/price, permit required, etc. custom ramp or Repour section + drain or New garage on the side with proper driveway slope. The most expensive, but then you gain a garage spot for the...

Static will not always occur with PVC pipes. It all depends of your setup. Usually, for smaller home DC system (under 5hp), static rarely occurs, there,s just not enought wood dust/velocity/air going in the tubes. BTW, you would have a better system if you switched to solid 4 inch pipes, but...

Like others said, horse stall mat. Thats what we have at the gym, and it's perfect when you drop your bar after a ******.

Something like this: http://www.thompsonswaterseal.com/waterproofing-products/waterproofers/clear-multi-surface-waterproofer You can spray it, roll it, brush it... You apply every few years to make sure, seals bricks, concrete, wood, and its clear once dried.