Recent content by Pa19331247

Just finishing up my 30 x 40 shop and realize it needs a urinal so I don't have to ,run to the house. I didn't put a toilet in as everyone said, don't go there with the city even though the city sewer line runs 15 feet from my shop. Also the neighbors are to close to go out the back door...

Thanks again guys, I think you have all convinced me to let this one go. It was tempting to have all the air i could ever hope for, but it looks like far to much trouble and expence. I will see if a 7 1/2 hp single phase will work. Thanks. D.

My neighbor offered my nice three phase ten horse air screw compressor for under a thousand bucks. The thing is spotless, however I don't know how many hours are on it. I only have 60 amps and single phase 220. Is there a reasonable way to convert it. Would a 10 horse single phase work. Thanks D

I am now about to start working on the siding and doors. My shop has two 10x8 doors which I would like to make as sliding barn style doors. My question is how do you make this style door mouse tight. Thanks, D.

Thanks guys for all you're help. I nailed up the fascia board on the sides of the shop which are two 2x6s, one over the other so 11 inches high. I do have a friend with a brake so will see how long it is and look for a roll of alum. With a white side. Thanks again

I am building a 30 x 40 shop with 12 ft. Walls. The problem I have run into is that the ends of the trusses are cut 6 1/2 inches high with a 2x4 purlin on top. So I am looking at a 9 inch total fascia drop. I could use two 6 inch alnm. Fascia panels, one down from the 2 x 4 and the other up...