Recent content by paul29

I have a Rotary SPOA10 this lift can be set up three different widths ( the upper bar is drilled for all widths and the cables are adjusted with schedule 40 pipe ) . It can be installed as a standard width , a narrow bay setting and as a extra narrow bay setting . I have it set at the standard...

The hot dawg has electronic ignition , no pilot .

kbs2244 : I guess there are a lot of houses with that design . The I beam carries the ends of the roof trusses which end over the garage area . The garage face was about a five foot offset to the front of the house at the end , a typical three bedroom bungalow . The garage door ended up about...

Had same problem on my previous home , had an I beam which restricted the use of a center mount . I had room to the right of my door so I mounted the t rail to the front wall and hung the unit to the right of the door , outside the rail same as a center mount . I welded up a bracket and mounted...

You will probably using an glycol solution , what would be your reason for draining ? It should be good for many years . Most Manufactures have a tech line for questions such as this . Takagi 's tech line is 1-888-882-5244 , I'm sure Bosch or whatever brand you decide on has the same service...

EDL : I think you will be much happier with a through the wall installation as it will be quieter ( the noisy parts are outside ) and more efficient. I just put a 15.1k btu unit in my garage , through the wall , not a difficult job at all ,the instructions are included with the units designed...

Couldn't agree more on the Takagi , Have a T-kd20 unit for domestic in home NGas . The rating for the Propane model is input 19,000 btu to a wooping 175,000 btu. Was told this unit would easily heat the whole house if I had infloor heat , i also don't see how the unit would short cycle as the...

Has anyone used Benjamin Moore pimer/paint on Hardiplank siding/trim ? Am getting ready to do trim and want to use one their colors.