Recent content by PeteDenmark

I get you, especially if it is mainly used for bikes. But mine is never used for bikes, but for lawn tractors and other small engine equipment, where the lip almost always hits right were the wheels are. The lift also seconds as a worktable, where i do welding and plasma cutting, where the lip...

I Created an account just to log in, and say awesome job. This is exactly what i was looking for. I'm going to copy your setup 1 to 1. Only thing i will do is cut of the lip along the side of the table, and weld another lip on the underside instead. I find the lip gets in the way a lot.