Recent content by phansen39

It's not going to bring the temperature down until it brings the humidity down. Is it pulling alot of water out of the air? Also running that set up only for an hour won't do much. Run it overnight.

Leak Stop Bad. Going to block up the metering device. The leak may happen only when running. Check the high side lines(the warm one) with dishsoap and water mixture.

Sounds like its in the wall. Alot cheaper to rerun the lineset than open up the walls. If ithe installation is new the lineset probably has a trim nail in it.

Reasonable mr tommy.. But how many Duomatic Olsens have you seen in the last 20 years.

No they don't. Good equipment/motors use ball bearing motors

You don't need a micron gage.

Even 115 is pretty hot for infloor heat. You say heating the shop. Sounds like you turn it off. A heating system like this is designed to be left on at a steady temperature. Takes a long time to heat the concrete slab.

And flood the furnace and floor with water. Don't do this.

What size/tonnage is the ac? Is house multi-story, How about windows, how much house faces south?

Just a quick search reveals this. " The pulleys are designed for 3L v-belts. Because of the location of the headstock pulley, removal of the headstock shaft is required to replace the v-belt, and this is not a task for the nervous: it requires driving the spindle out of pressed bearings. I...

Universal one here: ;)

Give him your Craftsman set and get yourself a Snap On set.:thumbup:

HD has ryobi 6 inch bench grinder for $24.88: http://www.homedepot.com/h_d1/N-5yc1v/R-203371439/h_d2/ProductDisplay?catalogId=10053&langId=-1&keyword=ryobi+bench+grinder&storeId=10051#.UK7nTYYbb4Y I actually picked it up Wednesday. They had a skid of them just sitting there. For light use is...

Imperial is near the top for gauge sets. Yellow Jacket Brutes are also very good. Course now I'm using these...

My main grinder is delta 8". But my little old craftman 5" died last night. It was actually my 1st power tool I purchased 1985. I was 14. So in the market for a new grinder for buffing and wire wheel. I'm thinking getting 2 one for wire wheel and another for buffing duties. I have little hf 5"...