Recent content by phisigbrotha

Did not end up doing that third coat. I have a few rollers marks that might drive me crazy later but after feeling the floor with bare feet after the second coat with anti-skid mixed in, I decided the floor would would be too much like coarse sandpaper. So I left it with just the two coats...

I wish I could give you an answer. I'm two coats into a Rust Bullet install on virgin concrete. New home build, CSP of 1. Put down first coat of plain in the afternoon. Second coat put down with 6oz in of anti-skid in 3.5 gallons of RB. I have 2.5 gallons left for a 600sqft floor. Since I have...

^this.

The oil wasn't as dirty as I thought it would be. But I have peace of mind knowing its clean now. Got a cheap regulator that will do for now from HF and a 50' 3/8" goodyear hose and assorted fittings. Once I'm sure I like where it rests I'll plumb some black iron to the center of the garage...

Picked up a compressor today from a neighbor a couple houses down. Guy said the knob on the regulator keeps coming off and he didn't want to mess with it. I just downloaded the manual for it and will looking to replace the regulator and do some maintenance before starting her up...

Thats damn sweet! Never seen a cooler clock. And a nice *** garage. My wife keeps me ill never have another street bike again. I still hold onto my rear wheel stand though.

I love the floor. Great color.

Thanks guys!

Who knows where the threads are now. Plumber said they deteriorated. And yes it was threaded into the brass tee. I'm assuming it was cross threaded originally. The plumber went to his truck and came back with the copper 5" ******. No adapter. Threaded it onto the tank and into the tee...

Hmm where are the threads?? The 5" ****** was replaced with copper. For peace of mind and a piece of my wallet I had a plumber come out. The ****** could have easily been replaced myself but I was concerned there might have been corrosion in the inlet of the tank. Thinking it was cross...

Its 105 here still so the "cold" water is actually hot.

Thanks Frank for the reply. It looks like the tank has a dedicated outlet and the three prong cord is intact. Im considering talking to the homebuilder warranty before tackling this myself since I don't think this will be covered by the tank's warranty. Would you say the builder should have...

Noticed last week my cold water inlet pipe is damp and has corrosion . It starts after the 3/4" tee fitting that goes to the expansion tank. Here is the hot water side. Copper flex pipe coming from the wall connected to copper pipe then connected to what looks like a 3/4 brass tee then to...

I used a 14mm and 15mm combination wrench. Put the 14mm closed end on the tensioner and lock the two open ends together. :fro:

I have two Seville tall cabinets. Even though they are not welded they are pretty sturdy once put together. Assembly isnt bad after the first one. I like everything about them but the gray finish, so i lightly sanded them and painted semigloss black. I also am not a fan of the diamond plate...