Recent content by PiDGE

look for heating appliances that are D.Vm(direct vent) These pull combustion air from outside and exhaust outside as well. Sometimes its a pipe in a pipe, say 7" round and inside there wil be 4" diameter pipe. Other times you'll need two holes (2 piper) just like Torqueman posted.

sometimes in a pinch on circut boards I'll give the relays a quick smack with a screwdriver to pop the internals loose. Guys I've worked with laugh and cant belive it. Might be worth a hot. If the board itself is fried then your sol.

Pressure plate to flywheel Sam.

well I've been on the lookout for days now tryin to do the same thing. Crossing fingers.

Hey people new here, just posted in the new member section with some pics of my rig. I'm on the lookout for a torx plus #55 and cant seem to find one anywhere I've looked. Matter of fact over half the people I talk to never even heard of such an animal. Can anyone on this board point me in the...

Gas valves in heating equipment. Not that I would try and take one apart to fix, just sell a new one.

Hey all stumbleled across this site while serching for a snap on or matco dealer in Ontario. Looking for a torx plus #55 for a clutch job this week on my little beast heres a few pics, I hope they come up for ya.