Recent content by Pinkfloydperson

I’ll have to double check the manual to see about the gas pressure. The code I’m getting off the board is a double blink on the LED, which translates to a no flame code. Like I said, once all the tubes finally light, it runs just fine and warms the shop right up, it’s just getting it to light...

The unit isn’t used. Just got it about three weeks ago, just hung it and wired it and whatnot over the weekend. The line is under 25’, and is 1/2”, running off of a full 100lb tank of propane. All steps were followed to convert to LP. According to my manometer, which is hooked to the manifold...

I just got done installing an 80,000 btu big maxx in my garage. I’m having problems with it igniting. When I can get it to light, it works as advertised. I’ve adjusted the manifold pressure according to the manual with a manometer to 10” WC as per my elevation (I’m located in Quakertown PA). The...

So it's starting to get cold out, and I'm still not 100% certain on what heater I should pick out. Does anyone have any suggestions on what brand and BTU I should be looking for and the best place to buy from? Any help would be hugely appreciated. Again, I'll be using propane, and I have...

Any specific suggestions on the heater itself and where to buy from?

That’s not really an option. Don’t want to deal with the oil, don’t have the space for an oil tank, and they’re pretty pricey to buy, even used.

My location is Quakertown Pennsylvania, about an hour west of Philadelphia. I plan on maintaining a temperature of about 50 throughout winter, and bumping it up a few nights a week and on weekends when I’m working or entertaining guests.

I have a 30x32 pole barn with a 14’ ceiling and two insulated 10x10 roll up doors. The walls are insulated with 1 1/2” foam board covered by 1/2” plywood. The ceiling will have 6” of insulation blown in once I’m all done wiring the building. I use a 28,500BTU air conditioner mounted in the...