Recent content by PMD1966

Worked in a stamping plant for a number of years. When a new press was installed, The base went in first, then the sides, crown was last. Tie rods were pumped with hydraulic fluid to stretch them a few mm. They were tightened to the max, then the hydraulic fluid was drained.

When I got into metric sizes, I went to eBay and bought everything, up to 35mm. Might never need them, until I do.

An **** Scope for a SnapOn Customer. Sounds Reasonable.

Set of bits for clutch head screws. Have only seen clutch heads once in my life (76 yrs old), but I am ready if I see them again.

Figured it weighed 20 tons or more.

Found a super, heavy duty canvas bag on the side of the road. I keep my concrete tools in it. Also saw an OBI press on the side of the road. Figured it weighed 20 tons or more.

Who is Guy Martin? What makes the SnapOn ratchets different with his name on them

Jay-Cee Rivets has a good selection.

When the struts on my 5-Drawer go bad, I will replace them with chain. Have seen a few carts with this mod.

Look at some of the photos. Some carts have a couple hundred pounds of tools attached.

Harley Davidson?

Had a neighbor who had a large moose head in his living room. The room was 10 by 12 feet. Head was really impressive.

Bought some tweezers from BUDK. They have a built in light and work quite well.

My son recently purchased a house. Had all the kitchen appliances. Looked in the dishwasher, it was covered with paint. Guess it was water-based latex.

Bought a S-K 3/8 60 years ago. Still going strong.