Recent content by polhub

Thanks, I refer to it as HF described it. It is well under 44" but I figure this crowd is aware (at least that is what I thought :)). So, based on the above, I am looking for a 41" wide 18" deep top box to fit on the HF 44"(that is really 41 1/2"). Gotta love the people in marketing...

Any ideas for a top chest to fit the Series 1 HF 44" box? Everything seems to have gone past 18" deep. I would like to go as wide as possible for the top box.

I have one and it works great for my small shop. I didn't use it as intended, I added better filtration and a separator. Plenty of air moves at the table saw and jointer. At the far end of the line I have a miter saw that is enclosed and the DC gets pretty much all the fine dust (not an easy...

LeeG, I like the idea of the slide outs, do you have any other info or pictures?

Gotta learn how he can snap 1" steel bar with his bare hands! ;-)

The Dust Deputy works vastly better than the Lee Valley cyclone lids for small lightweight dust.

You can use the Oneida Dust deputy and a 5 gallon bucket. http://www.oneida-air.com/category.asp?Id=%7BCC6B6F2A-E3D7-4F18-A53C-B5C357DFE131%7D They really work well with fine dust. I have a hepa on my Ridgid shop vac and the Dust Deputy in front, I have filled the bucket twice with sanding...

You can parallel the four pairs and get ~17awg which will work fine for the distances you have.

A Belden 2412 Cat6 cable will give you up to 10GBase-T to a maximum of 55 meters (~180ft). Plenty for futureproofing. As far a STP vs UTP there are some pros and cons for both (I am assuming you will run this in conduit out to the garage): STP Pros Will you to run your cable parallel to noisy...

Pool vac hose is longer and cheaper than shop vac only options and just as good.

They are at $199 now. Good deal, I may need to pick up a set.