Recent content by pontiacjeff

thanks indyokie and all the other responses. My water does have some iron in it. Main house just a large canister filter. I am going to install another filter before this water heater also. any other suggestions?

you are corrct, i prefer a tank and am leaning towards the 4 gall size as space difference and cost is minimal. this will only be used 8-9 months of the year and then drained inthe coldest months along withthe water in rest of building.

Looking at sma 2.5-4 gallon electric hot water heater for under a sink in the barn. Mostly for washing hands, my do some dishes once in a while. any preferences from standard HD or lowes offerings? I think i want one with stainless tank, but i would like to stay under $200. HD has bosch in...

my new garage is 34x40 on the 40 foot side we put 3 8 footers and put one 7 footer on the back corner i can put 5 cars in easily. and could squeeze more without the stairs or withthe wheel dollies, i think i could turn them sideaways and maybe get 11 or so. wouldnt be able to breathe in there...

We put ours up much like a chimeney. Flash and shingle around it good to go.

guy i worked with recommends portland cement. He says it pulls the moisture right out of the floor, balls up and then you can sweep it up. I have yet to try it but it is on my to do list. It is cheap enough.

mine is 34' deep and sloped. there is about 3'' difference from front garage door to back wall. Walls are level all the way out. poured not block walls though

took cylinder out yesterday after ordering rebuild kit. Rod is fine, orings and packing roached but worse is the inner bore of the cylinder. It is pitted, must have been stored with water in it. I am going to try and hone it so the seal will not get ruined, anyone aware of replacement or...

we just did/doing our barn roof. We ended up going with 40 year shingles. The look of th emetal roof is awesome, but we did not want to pay double price for it. Ours is 34x56, with a few pitch changes

ok guage check is good, it buries a 3000 psi guage as soon as you hit the button. Further review looks like the far side cylinder is not following the near side. Has hydraulic oil right to the bleeder. At this point I am ordering a rebuild kit for the cylinder and assume it is blowing by the...

motor definately working, i had removed motor from pump at assembly and everything looked good. I figured it wouldnt work at all if the plastic spur was shot i have a guage that was the direction i was headed too.

I purchased a used 9k Benwill lift. cleaded it up and installed and wired recently. I bled the system and lift moves up and down wo weight on it. Yesterday i decided to do trial by fire and put my f250 diesel extra cab on it. Approx 7800#s. The lift will start to elevate the body and extend...