Recent content by posservice

I just had a chance to check and you're correct. It is 14ga stranded. Sent from my LG-US996 using Tapatalk

Yes. This came from Bendpak and is 12ga stranded. I've seen some that said it was 14ga but when I spoke to Bendpak they said it was 12ga. Sent from my LG-US996 using Tapatalk

My circuit breaker is fairly close so I just shut off power to the unit when not in use. I may install a switch later on. Sent from my LG-US996 using Tapatalk

I recently installed my Bendpak lift and used 10/3 wire to a outlet in the ceiling. I then used rubber cord to the lift motor.

I have a F350 Crew Cab Diesel and went with a Bendpak 10K symmetrical. I wouldn't purchase anything less than 10K and out of everything I looked at along with the reviews of others on this site the Bendpak brand always stood out so that's what I went with. They were great to deal with. Sent...

Thank you. I did talk to BendPak who suggested replacing the rear arms with the longer arms from the asymmetric lift. They would be 8 inches longer.

Thank you, this is very helpful. The lift point you have on the front would work to reach the rear spots but the recommended spot is more forward under the radius arms. I may try your suggestion.

I just built a new building and I went with OSB again after my first garage build. Probably out of all the decisions I had to make, that was the toughest one. I screwed every panel instead of nailing. I did not paint the new OSB but the other garage I have, I primed and painted it white. I...

I searched the forums and see this being discussed but I have looked and tried every option to get this lift (Newly Installed BendPak XPR-10 in Wide Configuration) to hit the recommended jack/lift points. There is no way possible these arms will reach. Does anyone have good closeup pictures...

Just completed my first two post lift install thanks to the help from Jeff at Bendpak where I was able to test the fit and finish of the Gunmetal Gray. The lift arrived quickly and the paint color is very nice. The finish was smooth and the packing was perfect. Everything was clearly laid out...

Just completed my first two post lift install thanks to the help from Jeff at Bendpak where I was able to test the fit and finish of the Gunmetal Gray. The lift arrived quickly and the paint color is very nice. The finish was smooth and the packing was perfect. Everything was clearly laid...