Recent content by powpow

Yes, this is acoustic metal, not soffit metal. This is specific for use inside a building, just curious on the negatives to doing it on a ceiling vs top of walls. My lights will be recessed between the trusses so they will be flat to the ceiling, not below the metal

It doesn't say the open percentage, here is the link. https://www.menards.com/main/building-materials/pole-barn-post-frame-materials/steel-panels/white-acoustical-liner-panel/white1558185/p-1444448678798-c-5717.htm?tid=-1480537518223266793&ipos=1 I am getting it for 8 bucks per 16 ft sheet, I...

Anybody do the white liner tin on their entire ceiling? I am looking at doing a white vapor barrier, then the perforated liner tin with recessed 2x4 LED lighting between my trusses, then blow in insulation. My building is a 32x68 with a 3/12 vaulted truss inside, stick build Thoughts?

Here it sits, I now have tar paper on and will put ice and water on the edge when the snow blows off. I am hoping to start shingling in the next couple weeks depending on temps. The building will match my house, same color, siding, doors, etc as well as the stone on the front. The house I had...

Driveitsfar, Thanks, those are not mine, I do side work to pay for my shop. I primarily do body work, but at times, I will get requested to do the whole job. I have two more coming in, so I hope to move along pretty fast on my shop if all works out well. When I had teh foundation sitting...

last batch

more

1979 bronco and a 1956 ford

here is some of the past work I have done, new work will be done in my shop, hopefully next year

well, one week and the framing is all wrapped up. Primarily it was three of us, on a couple days we had a fourth. Now I start finishing up the interior wall framing, end gables inside for the vault so I can set up for sheet rock and liner tin. Depending on weather, I may start roofing in a...

The pics are from this morning, beautiful day to be outside. We sheeted 3 sides and started setting trusses, tomorrow, we should have the trusses on and sheeted

well Today was a wash out, rain in December in MN = no good We finished up a couple walls, hopefully tomorrow is a good day, get the front on and start sheeting,,,,we will see if Mother nature agrees!!!! More pics tomorrow

Well After 9 years of working my **** off and saving, I am finally building my shop. Short story 10 years ago my wife and I bought our land, we built our house, did about 60% ourselves, GC'd out the rest. I prepped up to build a 32x68 with room in attic trusses (county would not go more than...

where did you get the door track that follows your vault? Did you make them? Nice looking shop!

Thought I would give you an update,,,,decided to use the 250 xps, I went to a local lumber yard in st peter, MN, they can do it for me at $26.00 per sheet, menards was 30.53. I have more sand and gravel coming this week, 3 tri axle loads,,,,,hopefully will get me up to grade so I can get it...