Recent content by PrestonT23

Thanks for the replies everyone :thumbup: Ya'll been a great help! I'll take your advice and keep the pulley, I'm more interested in reducing the speed, hence buying JZiggy's slow speed setup, than increasing it. I'm going to start the disassembly soon, I'm sure I'll be back with more...

After some quick measurements, they do not seem to be concentric. Non-Ferrous. I haven't put it under any load but it appears to be running smoothly. run-out was about .007, off my cheap dial indicator. I tried with the hooks I have but, I don't have any small enough at this time to check...

And the measurements.

It was installed on the spindle when I bought it. The cylinder on top is original to the casting, I don't believe it was added. I took as many pictures as made sense with and without measurements. What do you'll think?

Guys, Thanks for the responses. I'll take lots of pictures and measurements when I get off work. Also, I'm in Northern California. I also ordered JZiggy's slow speed setup. I'm interested in disassembling the press, paining it and rebuilding it.

Hey all, Just picked up Craftsman 103.23141, my first drill press. I'm trying to figure out what spindle pulley I have sine it appears to be different then what I'm seeing in other pictures. The part number is 27415-103, but it only has 3 steps. from what I've seen, it seems that they typically...