Recent content by pst496

I see an elevator project in our future

Ryan, would really like to see more youtube content come from you. Whether it be garage journal related or gear, jalopy, dogfight or ford barn related

Just found this, I have a 66 i am starting and my dad has a 63 we are about 60% done with. you have given me a lot of ideas.

For those of you using the HF boxes and angle material - iron or aluminum to support the boxes. Do you notice any sagging issues with the middle of the box when storing heavier items? Working on my own design and want to go the angle route but I am afraid my boxes with 3/8, 1/2 hardware will sag

Femto is the way to go. Repeaters can and will cause problems to the providers network. if your signal is strong outside, you might get away with connecting two antennas, one outside, one inside. the out side antenna needs to be directional and pointing to your serving site. the cable...

mdbeck1 those bins have lips. same as the gray ones i use now. they donot fit well in the drawer. I will review again the other posts you suggested, thanks

thanks outlaw, I will take a look at them

So I have been obsessing over different organization strategies as of late – me and the wife purchased a new house, which means another garage, which is a clean slate so I am thinking of correcting a couple things that have bugged me over the years. This is a two sided issue that I am looking...

I dodn't know about the Northern Tool, this is getting better and better. Hope to run into some fellow GJ boys there soon, thanks for the feedback

Within 10 miles of me, I have a Lowe's, Home Depot, Hackman lumber yard, Ace and True Value hardware stores. Not to Mention Sears hardware and Harbor Freight. I see now they are building a Menards as well. I hear a little about it on threads here but What are the things I need to know and how...

I have used the aircraft versions for years on my drag car. Everywhere accept the engine. Suspinsion gets single use. 4link bars are an exception - those and everywhere else get multiple reuse. I have never had one back out

Re: Turner\'s Cube I really want one of these

Hmmm, well, blowing in insulation would be a pain but redrywalling would be worse. Any one done this? The blowing in insulation in a finished cavity bit. I guess you only need a hole the size of the pipe. i think the fact it is not insulated today would make it easier to run the electric...

So an update on planning this upgrade. Find out there is no insulation in the outer walls where i want to run the electric. Makes it easier to fish in the walls but now, what options do i have to insulate while the walls are finished?

Thanks shootingblanks, you have the same idea that i had, including running the air along the same route. I have options here as well as i have some reels hanging from the ceiling. All, no more opinionson the type of box to use? I was hoping to hear more options on what may be available and...