Recent content by q2quest

Wow, thanks so much for the detailed reply!

Thanks, I'll look into that.

You mean a baseboard tall enough to meet the drywall? Hmm, I hadn't considered that. That would have to be about 8 inches tall.

Hello everyone, I'm getting ready to put down a polyurea coating in my 23' x 23' garage and am trying to figure out how best to finish the floor at the wall. There is a stem wall all around the perimeter and where the floor meets the wall there is a 1/2" gap with fiberous board separating the...

I like that.

I really appreciate the replies. Tweaker47, are you still using the electronics and original control buttons? I think my motor is okay, but I have no way to control anything right now. It appears that there is a transformer running all of the electronics on 24 volts DC. If that's the case then...

Thanks Cyclehead. I can get a replacement motor. That's not a problem, but I did want to replace the control board and try again. I'd love to convert it to single phase power and it's likely not that difficult with substitute parts. I just don't have the knowledge or support from this supplier.

I'm hoping someone can help me. I purchased a lift from China after being inspired by this thread. I specified 240v, single phase power, but they sent me a 3 phase unit. They were very slow in resolving the issue so I went ahead and purchased a digital phase converter to convert to 3 phase. I...

Mine is 10 feet off the ground with a 12 foot ceiling with the vanes pointed at about a 30 degree angle. It seems to work fine that way.