Recent content by quicksilver74

the shop is just a metal building with the bubble wrap looking insulation. it isnt drafty at all but the insulation is less than ideal. forgot to mention it has 12ft ceilings with a center height of 17' how is the odor of the propane compared to the kerosene heater i am using now? i have never...

i have a 125K forced air diesel/kerosene heater in there now and it is doing the job but i'm tired of smelling like fuel every time i come in the house. i have a friend that has a brand new Hired Hand 225K BTU propane heater for sale for $375. i was considering getting it and hanging it from the...

called bendpak and they sent out a nice improved diagram. this is how i thought it should be done but at least i am sure of it now

I don't think both wires should go to the safety switch or the micro switch. If I read correctly they are only rated for 15 amps each.

can i just take the wire but off the white wire, disconnect it and run a wire up to the safety switch and one back down to the end of the white wire connected to the push button?? i thought only one wire connected to the push button rather than 2 wires and 2 inputs to the pump motor

he was paid a month ago when he wired the rest of the shop. i'm done with him and gonna do it myself. this is how it is right now

*************edit*********************** this is the new diagram from bendpak, hopefully it will help someone out so after paying $3400 to wire up my shop including the lift, my electrician showed up while i was at work yesterday and wired the lift as he saw fit. he screwed the...

ok guys, i just need to know how these fittings need to be clocked. i have attached pics to help identify what i am talking about. with the carriage lifted up on jack stands does it need to be this way or this way?

we got my new (scratched all to hell) lift almost installed yesterday. i followed the instructions and am at the part where the hydraulic hoses are being routed. i am lost as to how these are ran because the instructions are TERRIBLE and lack any real pictures. i have the 90* fittings...

i am having a 30x41 metal building put up at my house in the next month. i am wanting to buy a decent 2 post lift to make working on my cars a little easier as i found out last week dung my blower install that i am not 18 anymore. this lift will not see daily use and most likely only be used...