Recent content by QwikKotaTx

That's a giant lot for anywhere near Houston.

Great thread and impressive machinery.

I plumbed a small Makita compressor to a larger tank just to have a little more capacity but the pump and motor are still mounted to the original tank. It helps with the duty cycle a little bit. Sent from my moto g(7) play using Tapatalk

I made a wall space in my garage to put 4 bikes vertically with hooks to connect the front tire. It works well at keeping them out of the main garage area but a huge pain to take down or put back up. The kids don't put them back and the adult bikes were up high which is not easy on the back...

I use a programmable temperature controller I got off eBay to run a furnace blower as an attic vent fan. It has a thermocouple that triggers the circuit at 90 degrees or whatever I set it to and pulls a lot of air. It helps remove heat from the space above my ceiling which I am going to insulate...

My favorite screws are Spax. Awesome and strong. Home Depot has many different kinds. Sent from my moto g(7) play using Tapatalk

Wow, that is amazing. I'd love to hear the story behind that acquisition. Mine have 295's on the front and 335's on the rear. Road course tires.

That is sick. What does that wheel fit? I have some 17" OZ wheels off a Viper and the rears are at least 12" wide. They are Magnesium. Sent from my VS987 using Tapatalk

The Stanley versions are way nicer and worth the extra money, IMO. Sent from my VS987 using Tapatalk

I suspect that is true as well. As far as some wear to the rubber handle cover, it looks brand new. Most likely the wear is the cardboard rubbing on it. The refurbished unit cost me about $10 more due to the different coupon but it may be just fine. My old Craftsman has me jump like a scared cat...

Was it new or reconditioned? My reconditioned one showed up last night. I don't see anything broken. I am not 100% sure if it's brand new but it sure doesn't look used. I have not done the break in procedure yet but fired it up after adding oil to make sure it worked, nice and quiet. There was...

Sorry to hear about your MIL. Try to focus on the good times. Sent from my VS987 using Tapatalk

I'd say mine is in the middle and when it comes down crossways to where I park on the far side it has plenty of vehicle clearance as well as clearance between opposite wall and first step. It has been very nice to have compared to getting the ladder out and unsafely using the top of it to get in...

Amazing woodworking bench. Sent from my VS987 using Tapatalk

I don't think the cabinet I linked is available in store to look at. Will check Habitat Resale shop for sure. I will have some metal pegboard below the cabinet on a 1x4 to support the cabinets. Sent from my VS987 using Tapatalk