Recent content by RAM2940

Is it possible to open the motor and change the board and or is there a cap inside the motor.

Did he say " This is a holdup"

Im a HVAC mech, used this quite a bit doing condensor loop lines, but always wonder how long those orings are going to last. Dont think i would ever want to put this in a wall where you cant see it.

If your burning alot of propane with space heaters, your getting alot of moisture from that. Not removing the combustion gas and moisture. I noticed the propane in your pictures.

Is the new system setup as a dual fuel system. If so that would explain the heat pump cutting off and the aux heat coning on. If this is the case, you need to lower the changeover temp in the thermostat. Or there could be a setting wrong causing it to run as duel fuel instead of just being on...

Without the difusers on the ductwork, your just blowing the cold air straight down to the ground.

You at least had plenty of time for the concrete to setup. But really, Thats the kinda **** that will put you in the hospital.

I just put in a goodman 14 seer duel fuel 2.5 ton 60K BTU and its 14W X 53H

After watching the video, they are using the path of least resistance. When the compressor is not running power goes through CCH ( contactor open ) then through compressor windings, When contactor closes bypasses CCH (CCH has more R than closed contactor. Also not mentioned, if you have a 2...

BF315 The way you describe #2 the CCH will run only when the compressor is called to run.

You hook a manometer up to the pressure switches to see what the induced draft motor is pulling. Basically testing correct draw through heat exchanger. When you start adding and subtracting lenghs of pipe you slightly change the pressure across the heat exchanger.

Your installer needs to hook a manometer up to the pressure switches to see if the pressures are borderline to the pressure switch. When you start adding and subtracting lenghs of intake air pipe you start changing the pressure by small amounts. I went through a intermittant pressure switch...

Sounds like the inner wall is starting to rot, and condensate is getting into the outer wall and leaking out.

Very nice looking shop, im looking at having the same size built. Was this the same Pioneer out of Schuylkill Haven, PA.

BadMannerz I'm about 30 miles south in Nottoway Co, and interested in having a 30x40 pole barn built, would like to know if you could give me some names of builders that do work in this area that i could check out. And if you dont mind if you could tell me who built your building. Thanks.