Recent content by rao

That's why I wanted to avoid a union. Since I need one I will have to keep the union and the rest of the piping outside of the walls, which is not a big deal.

Thanks. I found some reverse threaded ******* at McMaster but that might be more trouble than it is worth.

It is designed to be mounted on the floor; the instructions show the minimum clearance to the floor to be 0". It is a sealed burner unit so it has air intake and exhaust from the outside.

Sounds good. I can do it all with hard pipe. I am trying to figure out a way to T into the line in the wall without using a union, but I don't think there is a way.

At loooooooong last, I am installing a heater in my garage. It is a Cozy Direct Vent Counterflow DVCF403B-H http://www.grainger.com/Grainger/items/1PKY9 I have the furnace mounted and the vent installed, last step is the gas line. I have located a gas line that I can tap into nearby on one...

You need a group buy for the bars :)

If you are going to MIG or use a plasma cutter, stay away.....

Great idea.

Used mine again this weekend, and I like it more and more each time that I use it. I also help a friend break down, move and install his 12 ton 2 post lift in his new shop, it took more than 5 minutes, fork lifts and a large truck ;) It turns out they are different :lol: but each one is good...

It looks like he bought several cross bars.

I bought one and am very happy with it.

Who is complaining? They wanted to use marketing BS about promises, and that is there choice. I put more than minimal effort into following their procedure for the group purchase which they contacted me about. I am not complaining at all, I am very happy with the result :)

Really? http://www.garagejournal.com/forum/showthread.php?t=30324 http://www.garagejournal.com/forum/showthread.php?t=28374 Glad to see this problem is being taken care of.

It also needs air flow into the shed for the compressor to compress :)

All you have to do is take a jack under the front side and lift up an inch or 2 and the lift will slide right under - I had to do this with a very low car that I used on my lift.