Recent content by ratchetbender

Not a moving part - Its made to be supported on the cast feet

It weighs 18 lbs.

Mystery Flat Anvil Pritchet or Hardy Holder 9" Triangle Was this used for forming sheet? Or Copper?

As you see the "down" valve shaft is turning as it should. It is no longer holding up my tractor. The jack will go up further easily, but not down.

I can't release pressure to lower the tractor I was servicing. I suspect that over a time of not being used, water is in this fluid. Rust?

The linkage is working properly. Peraps I'm asking which ball and spring to disassemble.

Delco 10 Ton Jack Model 34702. With the lowering valve open, It will no longer release its load. Is this made by Hein-Werner ? If so what is the equivalent Model Number, - X-10 ?

I have many of these without the "little wire". I assume not to use them. Will a setup like this work ?

I have a big job of parts rust removal. Thought I might as well gather up some selected salvage components for the job. I don't care to burn up any battery chargers. I'm using an 875 watt 24V AC transformer. What will these giant diode's resistance do to voltage drop in this setup. Will...

My motorhead friend has told me that this is a WW II Jeep 6 V generator . Could this be true? I have never seen one with a three bolt flange like this. Auto Lite - Stamped; M 4090 4H