Recent content by RBarnes

NIce Wlton patent pending on ebay.

Anyone have an older Wilton 800 bullet, 1960s, maybe 70s date code, with original swivel base and original paint (paint can be worn) for sale in the North Eastern United States? Looking for something in used decent original condition. Please private message me if you have one for sale.

I saw these but still holding out for an original.

Trying to find one of these original switch plates off a Delta grinder stand. Please private message if you have one you will sell.

Photos did not load in post above.

Spent a lot of time cleaning this 8 inch pot belly jointer down to original gray paint (then clear coated to preseve), rebulding motor and other restoration. Used my 6" jointer to straighten oak to make the wooden base. Last picture shows 6" LONG BED jointer in front of 8" pot belly. Not as...

Photos did not attach to my post asking about mobil base for 8" pot belly jointer.

I am about to start restoring an 8" pot belly Delta jointer. Thought it would be beneficial to first make a moble, rolling base for it. The type I have made for other heavy machines that I might need to move, are made from oak 2 x 4s, glued together with steel rods running through them. On...

Not that I can see, they are sold out of them.

Still trying to find an original RED DELTA switch plate to replace this one. Please let me know if you have one you will let go of

I am going to be parting out a 1938 Delta combion 10" tilting saw and 6" jointer in the near future. Does anyone know if there are parts unique to this earlier version as opposed to the 1940s/50s examples?

This photo was BEFORE I put the right 7 inch pulley on the motor - doing my test fit. Tighter than it looks.

My latest project. Probably will upset the purists, but my nature is always trying to upgrade things. Shoehorned a 1 hp motor into the cabinet, along with adding rubber dampening washers I hand made, on almost all screws to lessen the noise a little bit. This 1 hp motor will cut some wood...

Delete