Recent content by rbcsaver

My Bro-in-law had an excellent idea, when running outlets run a single 20A circuit, to each series (number your choice depending upon use) of upper outlets, then a separate line for the lowers. Snap out the tabs to keep them isolated. Thus if you have some cahrgers plugged into the upper outlet...

Yeah, huge floor drains like my mason put in, not those useless HomeLoweCheapo round ones. Don't know your location, put in a vapor barrier and foam insulation....the latter was an after-thought and too late for me, unfortunately. It's cold here in NE PA. I have a 4 post lift because I store...

Steve393 had a very goog write up and I used his experience as a guide and I would like to add some of my experience too. I had 3 kits to do 1200 square feet (30x40 ft). I placed all of the A components into one of the large (included) pails for color consistency. I then used my dry wall...

I sincerely doubt the MH would damage the tiles, as long as they are adhered properly to a flat floor without voids in concrete or adhesive under the tile. regards, Steve

Interesting, they told me 30 days, which was last Sat. and I planned on putting down the Epoxy Coat finish on my 30'x40' garage yesterday (Sun). However, there were still some damp spots in the stress cut edges and along the wall. So a no-go for a few days. I will add to the thread when that...

I too will try this. Just some caution, when welding, grinding cutting, that it is a flamable wood product. regards, Steve