Recent content by rclore

Thanks for the reply, I’ll give it another look.

Do you know what that part no. is? Because the F102860 only has 2 straight pipes, 1 that’s 12 in. and 1 that’s adjustable from 6 in. to 19 in. That’s the only kit that’s stainless steel and made for horizontal mounting. What am I missing.

Sorry for asking the same question but when I look at this stainless steel kit no. F102860 it only comes out to 31 in. in length, 37 in. with the elbow. How is everyone using this to get 5 ft. out of it. Are you buying 2 kits? Can I just run this straight out the back of the heater and right...

Yea that’s crazy expensive for only 5 ft. of pipe. I would need a 2-90 elbows anyhow because of where mine has to go through the existing 5 in. vent. My gas line, electrical, and hole through wall won’t work for turning it 45 degrees. Thanks for the reply.

Thanks. I wasn’t sure if I could reuse what’s there. It’s galvanized but in good condition.

Hi, this is my first post so wanted to say hi to everyone. I just purchased an 80,000 btu mr. heater. I had a older house furnace there previously and it had quit working. The old furnace had a 5in.pipe duct going through the wall. It had the the double walled pipe in a pipe that is still in...