Recent content by rcozzo

Similar advice to gregs, if you have some old speakers laying around just get a mini BT amp. I've got this one and it works great. https://www.amazon.com/BT20A-Bluetooth-Audio-Amplifier-Integrated/dp/B07BQC7GNL/?tag=atomicindus08-20

Re: what did you do in your garage today? I started my restoration project after a 6 year build. 1964 GTO video linked. http://m.youtube.com/watch?feature=plcp&v=gREESkfrsS8

I think you have a B3800 pump. If so, it looks like this will work: http://www.searspartsdirect.com/partsdirect/part-model/Kobalt-abac-america-Parts/Air-compressor-Parts/Model-K7060V/3244/0703000/50026510/00001?blt=06&prst=&shdMod=

I'm not a noise expert, but, here goes. The plastic filter I took off is a straight through design. The air travels straight into the slots on the outside, and continues in a straight line through a very porous piece of foam to the port. Other than the thin piece of foam, there is no sound...

The noise level difference would be worth another $50 to me.

Aren't those the same part numbers I posted in the picture of my invoice? Maybe a picture or dimensions of your inlet would be appropriate. I can measure anything you need from my setup.

Ah, I see now. Mine is for the 5HP,two stage. Yours is the 3HP, single stage? I first found those part numbers by hunting around the ABAC and Bellaire websites looking for similar pumps with better intake filters.

It turns this: Into this: The noise level difference after this change is huge. With the old intake filter the noise was deafening, and you couldn't stand to be near the compressor. With the new intake filter, it's much better. You can stand in front of the compressor and carry on a...

I just went through this. Here's what you need:. Order it from: http://www.allpartsinc.com/

64 Goat, every nut and bolt, frame off, rotisserie, etc. Should debut this summer. .

The trick I use to get the rubber and inner sleeve out is to run a drill bit through the rubber, then let it eat its way around the inner sleeve. Before you know it the rubber is gone and the inner sleeve comes right out. Try it, you'll be surprised, let the drill do the work. From that...

Really? What an ignorant statement. Do the calculations, I think you'll find there's less than 2V drop if using 12GA at 6A. Stlll 12V at the pump.

I've run my battery backup sump off my running truck. Generator died during a storm last year. I used two 50 ft extension cords. Cut off the plug on each end and soldered clamps on it. Worked fine. I kept those hacked cords as a backup backup.

Same here. The magnet stayed on my tool box the first time I took it off. Fortunately I had also bought the three super glue tubes for $0.99. A couple drops fixed it right up. Decent light for $3.

Not a picture, but a short video of my little "389". http://home.earthlink.net/~rcozzo804/64 389+.m4v