Recent content by realseriousschitt

sir how about using a real nice bit of exotic hardwood or go to a undertaker who makes coffins an ask for offcut mahogany?. make a series of progressive drill holes and your done.

hi on every length of pipe at joins and center dig in to the sub base and plant some old clay bricks or cinder blocks to the exact fall (making sure subbase is dugged until its clay)then in effect u have little piles to sit pipes onto the exact grade. in between thos piles just lay down some old...

here in New Zealand we have to apply for building consent even for drainage. this consent cost a percentile of project, but I cannot say I won or go given the materials for free years ago, its all based on market value. this consent system from council says its for safety and protection of...

hi on every length of pipe at joins and center dig in to the sub base and plant some old clay bricks or cinder blocks to the exact fall (making sure subbase is dugged until its clay)then in effect u have little piles to sit pipes onto the exact grade. in between thos piles just lay down some old...

this is absolutely nothing weight wise, a good bag barrow like the ones I used at the woolstore use to handle 160 kilograms without worries.

wow that's a e.v jeep....at lest its more reliable than my uropean market diesel j.k made in ohio.

hi. best bets are Ingersoll rand (u.s-italian), atlas copco, Hyundai, Kaiser (german)....go Kaiser or atlas-copco rotary screw if u want smooth and quiet running. Kaiser and atlas copco are top shelf seriousschitt gear.

O.k folks. I have a real problem. I have a European market jeep wrangler unlimited with a 2.8 c.r.d V.m diesel with stuck tite diesel injector in head. its resisted a 14 lb slide hammer on my initial attempt to pull. question I ask is what is the bestest most effectiverest penetrating oil out...

I have American made ''internationals'' is that waterloo?.

hi. I just use ratshits to run nutsnbolts up then use bar or ring spanner to titen up then torque wrench to finish. I avoid air tools on ratshits and just use cheap second hand wrenches to hold during rattling up.

hi. I wonder how they stack up compared to modern steel technologies like channellocks etc?.