Recent content by reb162

After looking at these ideas, I wanted to share my own oil and grease storage area. Thanks everyone for the ideas!

I wrestled with this as well. Finally decided to go with 12" square VCT tiles all around the bottom of the drywall. They fit relatively tight next to each other and you can caulk the bottom edge along the concrete to make it water proof. I used construction adhesive to attach them to the...

Found this thread looking to do exactly what the OP planned to do which was install an interlock on each one of my 150 AMP panels, run them to a J-box, and then single cable to the Generator plug outside so the Genny can feed both panels. Now I hear there is secondary neutral issue doing...

Thanks for ther advice, I will ensure the furnace exhaust stays away from the Condensor (not compressor ;) ). I'm going to pull the trigger tonight on one of the following two units: Ramsond 24000 BTU - COOL + HEAT (Heat Pump) + ELECTRIC HEAT...

Other than having min clearance per the manufacturers specs all around the compressor, what are the rules regarding the compressor placement out side by a wall. Specifically, the place where I want to put mine would be within 2 feet of the PVC intake and exhaust vents for my house high...

Any luck yet? I'm thinking of buying one but would like to know that cistomer service is good.

I like White, Grey, Blue and Black.

White Semi-Gloss. Use Semi-Gloss everywhere, you will not regret it!

OK. Got my stripes done and I thought I'd share. I think they turned out great. Only minor bleed through in a couple of locations that I need to touch up. Also got all my flourescent lights up which you can see...place is super bright now. Next step is to buy the cabinets and paint them and...

Thanks...working on lights tonight...stripes probably will not happen til next weekend..I'll post then. The Grey is Behr "Gray Area", code 770F-4 in semi-gloss

Problem is I do not have anything here that is Ford Blue...I could print it from my computer but I do not trust the computer and printer to replicate it. Second coat of grey is done and tape is removed....I'm real pleased with the sharpness of the lines. Only one or two bleed through spots...

First coat of grey went on this morning. It adds alot of color (or at least contrast) to the scheme...the all white was starting to freak me out.

Which one of these blues does everyone like better for the stripe...I'm trying to get close to ford blue: Behr Southern Blue Behr Sapphire Lace

Well, I got the line dividing the white and grey taped up tonight and put a light coat of white on the one edge to seal the tape before I paint the grey tomorrow (Pics below). My new Dewalt laser line level made staying level real easy. White painted over to seal the edge

Thanks all for the tips...the white semi did not leave any apparent lines. I'm going to start the grey today. Also, I'm looking for the stripe to be Ford blue. Whats the best way to get Home Depot to match this in Behr Paint...does anyone know of a Behr color that matches pretty close?