Recent content by Red55Belair

I have found that the jack is a Napa 91-642 2 ton. I was able to locate a model tag under about 6 coats of paint.

Yes it is a PHJ 60025. I’m trying to figure out who the original manufacturer was. I spoke with a representative from PHJ (professional hydraulic Jack) Hydraulics who stated the original owner of PHJ (Phil Peterson) repaired and sold old jacks as remanufactured units. Mr. Peterson has since...

This is what I have.

Sorry about the No pics.

I’m trying to identify this floor Jack. The best that I can make out off of the plate is B-42N02140. I bought a few years ago fro PHJ and have not been able to use it due to the handle not being able to tighten up the valve. It just spins. I have also discovered that there is a small leak at...

I used to work for Sears. They went to a 328. prefix in the 80's.

Thanks. I also purchased a jack from a re-builder in Wisconsin and it is supposed to be a Walker unit but it has so much paint on it I'm not sure what it is,,,it doesn't and hasn't worked very well since the purchase but was non-returnable. I won't be doing business with them again.

I am knew to this forum. I was a Sears parts manager for 16 years 27 years ago. I have 2 Sears jacks both Models are 727.12101 units. I know both were made by Blackhawk for Sears and appear to be the same as the Blackhawk SJ-2 models. Both of mine leak and I would like to repair them but do not...

I worked for Sears for many years in the Service Dept parts department. The Sears 1 1/2 ton 727.12101 floor jacks were made by Blackhawk for Sears. Whe Sears started trying to compete with overseas brands they went to the Model number prefix beginning with the 328. prefix. These were made in...