Recent content by Reddittj

No worries, I just wanted to join in, and just good timing for a contest! Thanks for the info. I will play with a larger hole this week. Picked up my motor and frame today, so I will try to do complete body work in next few months

I'm assuming I'm putting too much pressure with the press to get the deformation. The middle one I didn't press as far, I went till the sheet deflected back flat. I used a bolt on the middle and it was mostly straight. I have some knock out punches that I am tempted to try to create a...

Tinsmith, it didn't look like you have any issues with distortion? I was messing with ideas and most of the other ideas we had distorted the sheet too much. We work in natural gas so and there is always random stuff to use. That was the best we have came up with. We are not sheet metal workers...

This will be my first post on this forum, I usually just lurk around. I'm usually on offroad forums but the idea of dimpling led me here a few weeks ago. I'm building a 46 CJ2a and wanted to build some side steps with a few dimples. I've looked all over at some creative dimple techniques. I...