Recent content by Redwards329

As mentioned in a comment above mesh system for wireless. 75’ is nothing for todays wireless capabilities. With today’s wireless no need to bury wires and conduit etc. spend a couple hundred bucks on the mesh system, it’s plug and play. I’ve got a Linksys Velop 2 tower mesh system. One tower...

Beautiful area! I’m right down the road close to devils backbone. Holler at me if you need any skid steer work out there!

Here’s one I used 3/4” 4x6 stall matting for the back stop. Made a shelf on bottom to set broad head target below so I can shoot Field points then shoot broad heads at whatever distance I might be shooting.

I’m just down the road from you in between San Marcos and Wimberley, I built a 40x60 from DDM pipe and steel. Great building and folks to work with. Price beat mueller and metal mart. They have an office about 10 miles or so east of the airport. I did everything over the phone except pay them...

I just recently did mine. I went from well to shop and another from well to house and RV hook ups. All three runs have their own independent shut off valves. PVC is cheap and easy to lay in 20 ft sections with belled end. I ran all 1" and have good pressure at 125' feet from well house. I've got...

More progress has been made on the shop. Got lights up, a few work benches built, and 4x4 by 5/16 plate top welding table built. Scored 2 5hp 2 stage 80 gallon compressors that were a few months old for 1k. Sold the other to my buddy for $500. It's more air than I will ever need, but too good of...

The wire pull was a breeze. Half a bottle of lube and a friend pushing while I was pulling. 2 1/2 conduit really helped. Got my service panel in and one plug with a cord reel so I have electric. Once I finish siding the first 8 ft in plywood I'm going to run conduit and plugs on that. Spray foam...

My trailers will remain outside for now, until I build a shelter on the back side of the shop. I wanted that open canopy area to be able to have an area to work outside or sit and drink beer in a nice breeze. It faces east so that awning is compete shade all day. Probably put some tounge and...

Roof is on. some corner trim and few more closure strips and I'm ready for spray foam. Unloaded all my tools out of my enclosed trailer onto the awning. Thursday evening or Friday I will start moving in. Picking up my wire for electrical service when I get off shift tomorrow. Gonna be fun...

Couple more pictures I snapped before work. Spray foam is scheduled for the 7th! It's getting hot down here in Texas. Sent from my iPhone using The Garage Journal mobile app

Got most of the roof on yesterday. Should be done with the roof in a couple hours. Then we just have final trim and roll up doors. Sent from my iPhone using The Garage Journal mobile app

This is a bolt up kit from a place out of brenham, TX called DDM pipe and steel. Beat out muller and metal mart on price for the same specs.

There is one troweled in where the awning starts. I need to slap a diamond blade on my saw and make a couple more. Fingers crossed no cracks yet. I had to bring in quite a bit of spec base to level the site but I rolled with a vibratory roller in layers as we watered it. Under the pad is just...

All the iron is up. Ready for siding, trim and doors! Going to start back filling around the foundation with base tomorrow. Next step will be doing all my electrical and lighting. I've got 10 5k 48" LEDS might have to grab a few more for the gabled extension. Gathering some quotes for spray...

Progress for the day. Girts and remaining purlin on tomorrow and maybe some tin! Sent from my iPhone using The Garage Journal mobile app