Recent content by rentonhighlands

What does the 2x4 rafter ties look like? I know Simpson makes them but not sure what one you are referring to?

couch67 I took a look at your new shed page. What kind of siding did you use? I looks like metal to me.

Thank you everyone for all the information. To add and answer some of the questions. I am in western washingtion state. We do get snow but not much most of the time. I poured my concrete pad yesterday 8x12 5' door on the 8' side TR I like your suggestion. I want to built the rafters my...

Hello: I am building a 8x12 shed 16 oc with a 5' metal roll up door. I have some questions on how to build the roof rafters or trusses. The shed will not be insulated Walls will be 8' using 1 bottom plate and 2 top plates When I build the walls should I use 2 studs on each corner of each...

Ok It has been suggested I open the wall. I am finding the solution to be, I will need to wrap the pipe with some styrofoam type material the black pipe wrap stuff to make the pipe stop banging on the wall stud? Or if a strap is loose put a new ******** the pipe. This would make the pipe...

Thank you for all this information I fount the water pipe with the water valve exiting from the wall going to the cloths washer is loose. I can push the pipe in and out as it slides though the wall. However this is not where the noise is coming from however it is most likely tided to this pipe...

Hammer noise can come from either the hot or cold pipes. Has the banging been going on for a long time or just starting? The banging has been going on for a long time. It might occur longer if the pipe is in a lightly insulated or insulated outside wall where the cavity is cold. This...

Hello: I have a copper pipe making a clicking banging sound in the wall when the hot water from my kitchen (up stairs) is turned off after use. The clicking sound continues for about 30-45 minutes. I am wondering if this is water hammer? And or can be a loose pipe strap in the wall. I am...

Hello Members: I am looking for some troubleshooting steps. I picked up a old 1976 craftsman air compressor color brown 1 hp motor 2 gauges max number is 160 psi This is how it act now plug it in and turn on starts running pumps up to 100 and sounds normal at this point the motor starts to...

How can I tell what load I am putting to it? I have them wired on a 15 AMP breaker 14/2 romex wire and I have 10 of them on 1 circuit. My sub panel has 100 AMPs to the panel.

what does this mean? Maybe the OP over drive those Triac base drivers.....

All of them. I am not in a good spot as I have ripped up the original boxes. I ordered them online at the Home Depot site.

Would adding a dimmer switch help or change anything?

I guess I am going to take them down and return them to home depot or work with Eaton in some way with the warranty. What is a different 4' LED light you would recommend. I can not have this buzz that is the most annoying thing in the world.

I got it figured out. Here is a pic