Recent content by richard7

I need to get serial # off motor and research the fan was available in 2 speed version. We have similar fans at bodyshop but they spin a good bit slower. This fan is really moving its a 36in out performing 48 in

Sorry for the hijack. The motor does have several extra pins that the wiring harness is not using. I wonder if moving the hot to a different pin changes the rpm.

Nice bandsaw and stand by the way.

What is the difference between a 1 speed single phase and a 2 speed single phase motor ? Would like to hear I just need a 2 speed switch. It is an 8 amp motor belt drive exhaust fan want to slow it down sometimes. thanks

I want to know too. How can you tell which ac motors you can speed control from ones you can not

Thanks everyone for the advise.Running 2 layers same direction, staggering joints both directions sounds like the best advise.

good read i wonder if their product is osb material?

Thanks passnthru,

Plan was nail down 1st layer then nail down second layer running the sheets the opposite direction with maybe glue between sheets.posting here cause i wanted your opinion not the counties . I am pretty sure 3/4 osb would be recommended but would 7/16 x 2 perform just as well or even better? I...

1st floor office 2nd floor is storage

framing office in shop roughly 13x17 . 2x10 floor joist on 16 center for 2nd floor . I have a whole lot of 7/16 osb wanted your opinion on doubling it up for the flooring will be used for storage space. Run it both ways with glue between ? what do you all think thanks

hey rockcrawler what did you pay for the door security bar ? might have to get one if there reasonable

A small check valve after the hose air chuck? Iquess would hold all that air in the hose till you discharged it at the coupling. Never heard of anyone doing that i would buy more hoses so your not having to disconnect them often. I agree that disconnecting charged hoses should be done with care.

milton is a good choice.Prevost makes couplers and fittings that are real good but are expensive.We use Prevost high flow at work in the paint shop. Bodyshop uses regular flow so your always using an adapter to paint i n bodyshop.bodymen have adapter to use there tools in paint shop been like...

Love my ego 650 cfm blower and chainsaw it will blow 850ft of driveway,around pool,porches,patio on one charge. I notice i keep the place up better .I only use the gas backpack blower 2or 3 times ayear now,the ego blower blows harder than my sthil br400 just not as long of course. I had my ego...