Recent content by richas

Unfortunatly the top is packed full.

Here is a picture of the conduit and panel. How about this. Replace the last 90 degree bend with a 45. That would run vertically down into a separate junction box. Then metal conduit horizontally to the main panel. The metal conduit and box would be grounded by being connected to the...

Thank you all for the suggestions. Unfortunately I have not found a good solution to this. The panel is in the basement against a foundation wall, sub grade, sonitbis not possible to come into the back of the panel. The lb enters the side of the house above the panel between the floor joists...

I have buried 1 1/4" conduit to install a 50A subpanel between the house and detached garage. I will bring the conduit inside through LB boxes. What do I do on the inside? In other words, what is the proper way to direct to wires to the mainpanel and to the subpanel? PVC conduit? Metal...

Yeah, especially since I have a basement! :P I am reluctant to drill holes through the foundation wall, perhaps i need to bring it up above the sill plate......... Rich

I have purused the forum for info and it has been helpful. I am replacing my driveway and am going to take the opportunity to bury new conduit to my detached garage and install a sub-panel to supply 240V to the garage. At this point I will just concern myself with the conduit. The current...