Recent content by Rigging65

My tablet is only 24”x48”, but it’s built out of light square tubing, then I took two pieces of 48” angle iron, with the outside angle pointing up like an arrow towards the roof, and cut kerfs through it about 3/4 of full depth. These kerfs are about every inch. These rails are mounted on either...

This is a powder coating station I built. The blaster cabinet sits on top, and the fold out table allows for a pop up spray tent to sit on top. There’s slide out storage for powder bottles and a top tray for the gun and other ‘stuff’. Under the slide out tray is storage for the spray tent, a box...

Yeah, I agree. I contemplated paying to have it dear coated, but that seem kinda silly. I’m going to end up painting it unfortunately. I want to do a little filler work on the media drain chute out the back anyway, and that’s easier to accomplish if I’m painting it an not baking it. Oh well...

All good info. Thanks for the input! I don’t find any heat coming off the oven at all, but it’s good info!

Not at all...everything stays room temp. There’s an air gap around the oven, but the oven’s insulation keeps everything nice and cool

I skinned the whole surround of the over, including the top deck in sheet steel. You can’t see it well, but I built a trough/drain into the top deck (above the oven, below the blaster cabinet) to allow the media to dump out the back side. The blasting cabinet legs are so short that the drain is...

So I got tired of my painted metal projects getting scraped and dinged, so I decided to start powder coating. Well, I’ve got limited room in my shop/garage, so I set about building a trolly to hold my oven, a media blaster, and a fold out table to support a pop-up spray tent. It took a while to...