Recent content by Riverfront

Milwaukee M18 FUEL 1/2" High Torque Impact Wrench with Friction Ring - 2967-20, tool only. @Murdoch's $223.99 Promo code: 24TDEJRBMS...

in mine the slides were evenly spaced top to bottom and the deeper drawers had 2 slide on them. I hit the releases and pulled out the top 2 and the top deep and then swapped locations took maybe 5 minutes and no tools

It works I did just that on mine, liked keeping the impact in that drawer easy to get to.

http://en.wikipedia.org/wiki/Lahti_L-39 they rebuilt one on "Sons of Guns" on history channel recently

HARRY J. EPSTEIN CO should have you covered

Dump both and buy a Smith torch rig.

How did you pipe to the table saw? I got lucky in my new shop and got 4" PVC and 1-1/4" conduit under the floor before it was poured. Haven't gotten the dust collector hooked up but I'm getting closer to that point.

If there is another of these floating around I'd like one too! I'm looking to buy a metal bandsaw.

Midwest snips and their made in the USA

I'd leave the front unbent and with 3" of overhang so its easier to clamp stuff down if needed.

I'll take the Wright 2400

pm on Wright Wrenches

Anybody know if you can rearrange the drawers in the 36" roller box Menards sells under the Masterforce brand? Thanks Riverfront

Williams has you covered http://www.jhwilliamstoolgroup.com/Cat-21-1-193/Open_End.htm and the handles http://www.jhwilliamstoolgroup.com/Cat-21-1-192/Handles.htm

this with whatever handle length you need http://cgi.ebay.com/NEW-WILLIAMS-TOOLS-BIG-BOX-END-WRENCH-1-7-16-36MM-/280429478851?pt=LH_DefaultDomain_0&hash=item414ae643c3