Recent content by RJSenn

Bought my first Koken Z 72T 3/8 flex head ratchet this past Christmas. It's a fine tool and this weekend warrior prefers it over my low tooth SK or Snap on ratchets. I see more in my future...Waiting for their 72T 1/4" to come out.

HF can def be hit or miss - I had that experience with their "purple" hvlp gun that everyone had good luck with. It was broken right out of the box. But...I bought the HF ultrasonic cleaner for a stubborn motorcycle carb that would not co-operate. I had to run the carb on one side then flip it...

no Idea - I'd have to ck and get back to ya. I didn't see any other plastic parts, except the small levers that you have to push up/down to remove the drawers.

Hans, post a pic when you can- I’d like to see it.

Ya, that's a tough call. I have a Kennedy red 5 drawer roller, that is in great shape but the paint is faded and if I paint it, I'll do it myself with Rustoleum thru my LVLP set up. I Picked that up for a steal $30. Your green kennedy would be cooI to freshen up. I spent a bit more than I...

It's hard rubber - I don't know enough about 3d to know if you can print that type of material. They were $5 and change for 4 of them from Kennedy.

yes, I agree. I had been looking for a brown kennedy roller to use with my small machinest chest. This one came up and although I didn't need both boxes, it was local and looked to be in good shape. To be honest, I didn't see it in person until I picked it up. I was pleasantly surprised it had...

I recently won a Kennedy versa cart from a local auction and when I picked it up the ball bearing drawers were opening on their own. I searched many places and didn’t find a solution. I pulled a few drawers off their rails and noticed black rubber chunks in some of the drawers and in the bottom...