Recent content by RMS52

thanks for the Werner link. Never thought about looking the manufacturer up.

I have a 10' two man step ladder in good shape except for the outside surface of one rail has had the epoxy over coat worn off. What type of coating do I need to get to recoat the rail?

Verify the alignment of the two fittings. The two ends should touch either other and there should be no angular or side to side offset. The collar is not made to align the union ends; just to put pressure on the matching end surfaces.

Never knew the Workmate had such a following. I got for Christmas in 1978 I believe. Just looked up the instruction manual and found the bottom half of the registration card. The card has this on it: Division 1 Catalog Number 79001 Product Code 679001 Mfg Week 190 Lot Number 87 Type Code 6...

I would not have the air connection pointing to the side or up. By mounting the connection chest height or lower and pointing down there is little chance of any of the compressed air or its contaminates blowing into your face and possiby eyes. Also pointing down allows you to use the connection...

I normally use a Dewalt 18V, with the XRP battery. For the larger jobs I have a DeWalt 24V drill. Roger