Recent content by Rnbuck01

I'd think it would dump the water heater out too fast if you go any higer.

So let's say 60,000 btu needed would be 6 gallons a minute. .75 head feet per loop x 6 is 4.5 feet then + 2 would be close to 7 head feet.

How come is there a valve right above your mixing valve?

I am figuring that my head feet is around 5-6 then you add 2 more feet to get 7 head feet. It's a 1500 square foot building.

I was doing some math for a pump size for my system. I have 6 loops of 250 ft. Am i better off with going with the 006 or the 007 ? I will be using at least a 40 gallon water heater. Dont want to have any excess noise while running the system.

You have the attic insulated right, why not insulate the walls right also?

Was plan on running a high efficiency water heater. Could I run straight water with water wetter so I stay away from it corroding?

How much does 1 gallon of antifreeze cover? I got 6 loops of 250 maybe 300 feet.

It'll still corrode using nontoxic anti freeze?

Somebody put the wrong tubing in before pouring the concrete.

If I use the right antifreeze there shouldn't be too much corrosion, or does the antifreeze start corroding once it comes in contact with oxygen?

how long will it take before you start to see corrosion in the plumbing parts?

What temp could I safely heat my water in my in floor heat system just using regular pex?

I got a sensor coming. So will it go into defrost if it's above 28 degrees?

I went out to test the defrost thermostat sensor and got an OL on my meter which means it's open. If that sensors bad, will it cause it to not go into defrost?