Recent content by ronkesti

your correct the outside socket is male

It actually does not have a label or specify mod # it just says item 63970 EPA 111

Ok won't do that then thanks would you know how to unbond a 9000watt predator Gen

Thanks

OK thanks OK thanks

The outdoor plug in is a female 4 prong twistlock nema #L14-30 inside a weather proof housing which i plug the gen into. The interlock is on the fuse panel which won't allow me to switch to the gen without turning off the main incoming power

I was told that I could remove the ground wire at the breaker panel and that would achieve the same thing. What do you think

Sorry I wasn't clearer I was talking about the bars in my breaker panel where white wires go to the left bar and green to the right side.

Thanks That's what I suspected but wasn't sure

Hi from reading the forums I am still unsure. my portable generator is neutraly bonded to the frame I ran the 4 prong twistlock nema #L14-30 to out side plugin then ran 4 seperate 10 ga wires two hots to 30 amp double breaker, white to left bar and green to right bar at 220 amp fuse panel...