Recent content by ronzmtrwrx

Hmm. Don’t know why those loaded sideways.

Me and a buddy are wiring my new shop. I’m pretty happy with how it’s going. The offsets are the hardest for us being novice pipe benders, but we’re getting there.

Thanks. I sure would like to do the floor in a light color epoxy, but the cost of doing 3000 sf will probably nix that thought. At the very least, I need to seal it to try and protect against oil spills or whatever else might happen. I’ve read through so many threads on the floor coating issue...

Thanks Svend. No, I didn’t run any dimming wires.

Just thought I’d post an update on my lighting project. I had Platonic Solid work up a lighting layout plan for me and I am very happy with the results. I used 20 110W 1’x2’ LED panel fixtures. I have yet to install the strip lights over the assembly room to illuminate that area, but the work...

Thanks. I'm anxious to get it finished and functional. I'm happy with the way it turned out.

This cost me 20k. It’s a 50 x 60 at 6” thick. 83 yards including footing pour. Drilled into existing floor and rebar driven in. Upright and linear rebar in footing. Wire panels tied together in floor. This also included almost 30” of crushed gravel built up on slope and vibratory compacted...

I’m in the final stages of construction of my new shop addition and am ready to start my inside electrical. I have looked through countless posts on the lighting thread and I’m still not sure which way to go. First off, I do mostly automotive work, fabricating and builds, some motorcycle work as...