Recent content by roverhybrids

I just finished building a house on approx 90 x 120' lot with about 16' of slope from the front to the back. I had to remove over 100 yards or dirt($10k+) Had to have engineered retaining wall/footings for slab($10k+) Had to have retaining wall down on side of property($5k+) Where I'm at you...

put in a water line to California!

I need one!

Are you talking set: 313tsmya 12-24mm retail $452 313TSYA 3/8-1 1/8 retail $477 plus S80 ratchet retail $149 total retail $1078 for $350? what was the question?

if you don't mind me asking how much $$$ did all that set you back? did you buy a package or get it all on a deal?

I saw this thread title and thought, do I really want to wait to open this thread??? apparently.....

subscribed

I believe v28 is obsolete. the new batteries are m28, just like the 12v and 18v are m12 and m18.

I have the skil HD77 mag-lt I would buy it again

Re: Building the Ideal Mancave I would use Titan HD bolts to screw it to the floor. It would be easier to move/remove later. My experience with the powder actuated nailers it that they don't always sink the nail in cured concrete...

my local tool fastener store has/had dewalt bags from tool kits for $2.50!

S80/S80a is on my list.

thanks for all the replies. I have 3/8" and 1/2" Craftsman RP ratchets. I sort of like the 1/2", but I hate the 3/8's. I never use them. I have 11 Snap-on ratchets, but no dual 80 in 1/2" drive. I am only considering the Craftsman thin USA made in 60t or the Craftsman premiums 84t.

I've been working construction for the last couple of years and haven't put much thought into tools for working on vehicle for a while. I'm a bit surprised to see Craftsman's made in USA products are disappearing. I use to have a pretty good selection of Craftsman tools that I sold off as I...

top once more.