Recent content by rubadub

Thanks men I'm all set the bolt is tight and it's shiny from when we replaced the springs before. Thanks again I appreciate it. Rob

My 16' x 7' high insulated garage door. I'm picture taking dumb plus I don't have a new type camera, anyway thank you for inquiring. Rob

I was just looking at my torsion springs and its shiny a bout 4 inches wide on both sides of the torsion spring rod, maybe it was like that when I worked on it a few years ago, or is the right and left torsion springs moving. Thanks in advance Rob

I have a kent moore turret cabinet intack and good shape with the name plate on the front that says. Kent Moore Endorsed Service Equiptment Detroit Michigan. Rob Milks two rivers wi. 920 553 1708 [email protected]

I just finished this up tonight. http://www.1969supersport.com/01trailer13.html On my web site theres 10 segments to it if anybody is interested, its under trailer. Heres my web site. http://www.1969supersport.com/ Rob

Wow, lots of good responses men, the spring loaded one with a rope or chain on it I think will do the trick. I never would of thought of the spring loaded one. Thanks again men.:thumbup: Rob

I have a shed, the last picture down http://www.1969supersport.com/dog4.html shows the front of it behind my dog Buster. Anyway it has a couple latches at the top to help keep it from swinging out a little where the center lock ( latch ) will prevent it from coming completely open. I have a...

http://www.1969supersport.com/welder.html Rob http://www.1969supersport.com

Heres this, the last guy that posted has a pretty good answer I would say. http://www.hotrodders.com/forum/best-way-mask-paint-fumes-98894.html?highlight=filter+paint+fumes Rob http://www.1969supersport.com

Its always pretty clean, and when I change the oil I clean it like they say, but most all the dirt in the air is in my paint booth so its getting pretty decent air. I also keep tabs on the duty cycle and don't over work it. I run it up to 175psi thats where it shuts off, I usually run 95psi...

Some installations slope the main line away from the compressor so that the moisture flows with the air flow towards a drain leg at the end of the line. In some installations the end of the line is sufficiently close to the compressor that an automatic drain valve can be used otherwise the drain...

I have three hose reels, one in the overhead, three drains, you should be able to see all of them here. http://www.1969supersport.com/paintroom.html Yes long runs to cool the hot air out of the compressor. Just guessing here, maybe 70 feet out of the compressor before it goes into three...

Heres some stuff you could look at. http://www.1969supersport.com/draw1.html http://www.1969supersport.com/airsand.html Rob http://www.1969supersport.com

Heres some stuff on respirators if anybody would care to look at it. http://www.1969supersport.com/respirators.html Rob Http://www.1969supersport.com

Heres mine http://www.1969supersport.com/paintroom21.html Rob http://www.1969supersport.com