Recent content by rXc3NtR1c

I wouldn't be too concerned about the 1/4 inch. We built our drag car with the same bender and aspired to within 1-2mm. Some areas are and some aren't, the thing that we learnt is that when you deal with mass produced bodies there will be more "aren't". My rule of thumb basically changed to if...

The other thing to keep in mind is that if you're using stainless, then you will only be able to single flare due to the hardness of the tube. This is not really an issue however single flares are prone to leaking. If you are using AN/JIC tube nuts and fittings also be aware that the 37 degree...

I have the Ryobi 1 version of the Ozito one, cordless if that's your jam. Great machine and very handy :) Results much like the ones above from Gregor and his air powered one, which I must say are amazing as usual.

I'm a lurker, I enjoy watching you do your stuff both as inspiration and instruction. However, Fantastic Mr Fox is comment worthy lol, I don't know how many times I seen it in the last few years. Whistle whistle, click click ;)

Me too. I like out of the box / left field stuff. Sometimes it's hard to let go of preconceived ideas but once you're past it I find I'm usually wondering why I didn't do that sooner :)

I do a lot of lurking, but this is one of the threads I follow. Keep up the good work :thumbup:

Pic 1, would be a more even distribution of light looking at your diagrams. Edit: Wow, first post. I thought I had done that before now! :bounce: Tone