Recent content by ryunk

  1. R

    Bathroom in 40x60 Shop Wiring Question

    I plan to provide a single 20A GFCI branch to my single bathroom receptacles and lighting (one receptacle and two light fixtures). I also want to provide this branch power to three receptacle boxes that are in the bathroom walls but facing to the outside of the bathroom (essentially supplying...
  2. R

    Mr heater users on here?

    I bought a thermostat from a local HVAC supply house. It goes down to 45 degrees which is 5 degrees lower than most of them. I think it was a ISC1600 or something like that. Lowes and Home Depot have a good supply on them.
  3. R

    Are Hot Dawgs quiet?

    I also have a Mr. Heater 75K BTU and I am pleased at how quiet it is.
  4. R

    Can I hook the flexible gas line directly into the heater?

    Most likely - Yes But I would check with your local building codes to make sure. I called our local inspector and verified that I could use flexible pipe to hook gas up to the furnace.
  5. R

    Yes more heater installation questions!!!

    1. I too purchased two 60" ceiling fans for my garage for getting the heat from the ceiling to the floor. I have a 75000 BTU Mr. Heater up close to a 12' high ceiling. The Home Depot commercial grade 60" fans are great. 2. Do not purchase the vent kit from Norther Tool, I had to send it...
  6. R

    Mr Heater Universal Gas Kit

    I just hooked up the gas line to the 75000 BTU Mr. Heater unit and got it going last night. I went to a contractor supply house and bought a 5' flexible gas line. The description read "7/8 60IN SS GAS CONNECTOR" part # FL 30-3141-60, there was a 3/4" male end on one side and a 1/2" male end...
Top Bottom