Sanderguy777's latest activity
-
SSanderguy777 replied to the thread Ridgid tools good still?.Ok. I called Ridgid and they told me I have to drive an hour and a half to a service center! What have your experiences been with...
-
SSanderguy777 reacted to RTM's post in the thread Best table saw blade (can I cut nails with it?) with
Like.
I had a $hit sharpening job destroy my quality of cut on my Craftsman contractors saw. My glue ready cut went to bad quality. Took my... -
SSanderguy777 replied to the thread Best table saw blade (can I cut nails with it?).The saw wasn't expensive, but it's from the 50s or 60s, so it's not junk, either. I would also argue that once the blade isn't...
-
SSanderguy777 reacted to seber's post in the thread Best table saw blade (can I cut nails with it?) with Like.
90% of the cut quality is the saw and the setup. Don't waste money on an expensive blade for a cheap saw.
-
SSanderguy777 replied to the thread Best table saw blade (can I cut nails with it?).Someone made a 24" saw once too, and that one handles 8x8s 😂 I've been tempted to try putting a 12" blade on it, but never thought it...
-
SSanderguy777 reacted to RTM's post in the thread Best table saw blade (can I cut nails with it?) with Like.
My old CMan saw can run a 12", 4x4 rough cut lumber, no problem.😉
-
SSanderguy777 reacted to Steve_P's post in the thread Best table saw blade (can I cut nails with it?) with Like.
Another vote for Diablo but I'm not going to vouch for surviving nails other than as shown on a circular saw in the Project Farm test...
-
SSanderguy777 replied to the thread Ridgid tools good still?.Oh, for sure. If I started over or was planning on doing a big job, that would be perfect. I just don't have anything to draw me to...
-
SI like the 18v Milwaukee nailers. Those and the PEX A tools are the reasons I started with Milwaukee. Now I have drills drivers...
-
SSanderguy777 replied to the thread Ridgid tools good still?.I should have been more clear. I was talking about the m12 non-fuel tools I have. Ridgid did offer 12v tools at one time, but they went...
-
SNo sorry 18v, I thought you were saying your 18v Ridgid drill and impact driver were really weak. I didn't know they offered a 12v so I...
-
SSanderguy777 replied to the thread Ridgid tools good still?.Ah, those are really good points! I didn't know the riving knife issue or the battery issue. There is a CMT (I think it was) blade that...
-
SI don’t know jack about festool. Just verify you can run Diablo or Freud blades in them. You basically can’t in the Milwaukee. For...
-
SSanderguy777 replied to the thread Ridgid tools good still?.Porter Cable was MAYBE Ryobi quality. Flex was a newcomer that died off for whatever reason. Ridgid is a plumbing company with a good...
-
SThis is all fine until you need to do something in your attic with no power outlets or lights. By the time you run the extension cord...