Recent content by satchm0h

Thanks @FrankLee and @11b30b4 . I appreciate the pointers. I am on travel for work, but will try out some of your suggestions this weekend. Note, I did remove the quill lock and it had no effect on the issue. I also tried removing the set screws that modify the gap on the head to see if it was...

Hey folks, n00b here. I was recently gifted a 113.24611 (Gen 3.5 per @11b30b4 's spreadsheet). I brought it home and plugged it in. The Motor/Pullys/Spindle are all turning smooth. However, the feed is super stiff and only has about 1" travel down from the top. It does not spring back either. It...